Mechanical engineering topic list of research papers
-
Nonlinear dynamic analysis of nuclear fuels considering thermo-elastic-plastic-creep phenomena2016 / Y.-D. Kwon, B.-K. Shim, J.-M. Song
-
Cutting Performance Evaluation of End Mills for Titanium Aircraft Components
Abstract Titanium aircraft component has been considering difficult-to-cut not only for the poor machinability of material itself but also for the complexity of its structure which generally consists of thin-ribs, thin-webs, corners, pockets, etc....
2015 / Wei Zhao, Shengzhang Wang, Zhiwei Han, Ning He -
Dispersion stability and thermophysical properties of environmentally friendly graphite oil-based nanofluids used in machining2016 / Y. Su, L. Gong, D. Chen
-
Curvature-adapted Remeshing of CAD Surfaces
Abstract A common representation of surfaces with complicated topology and geometry is through composite parametric surfaces as is the case for most CAD modelers. A challenging problem is how to generate a mesh of such a surface that well...
2014 / Franco Dassi, Andrea Mola, Hang Si -
Product architecture design of multi-modal products2016 / Cong Liu, Hans Petter Hildre, Houxiang Zhang, Terje Rølvåg
-
Numerical Evaluation of the Applicability of Steady Test Bench Swirl Ratios to Diesel Engine Dynamic Conditions
Abstract Engine coherent flow structures such as swirl and tumble motions are key factors for the combustion process due to their capability to rise turbulence levels and enhance mixing which, in turns, severely influence both fuel efficiency and...
2015 / Forte Claudio, Catellani Cristian, Cazzoli Giulio, Bianchi Gian Marco, Falfari Stefania, et al. -
Experimental and numerical study on ice resistance for icebreaking vessels2015 / Jian Hu, Li Zhou
-
Identification of the heat transfer coefficient in phase change problems2010 / Damian Słota
-
Supercritical fluid recycle for surge control of CO2 centrifugal compressors
Abstract This paper presents computer-based design and analysis of control systems for centrifugal compressors when the operating fluid is supercritical CO2. It reports a non-linear dynamic model including a main forward...
2016 / Sara Budinis, Nina F. Thornhill -
Validity of Mechanical Power Output Measurement at Bench Press Exercise2009 / Daniel Jandaĉka, František Vaverka
-
Stochastic time-dependent vehicle routing problem: Mathematical models and ant colony algorithm2015 / Z. Duan, S. Sun, S. Sun, W. Li
-
Compression Chamber of an SI Engine with Increased Turbulence2013 / Stanislav Beroun, Pavel Brabec, Václav Dvořák, František Maleček
-
A numerical study on manoeuvrability of wind turbine installation vessel using OpenFOAM2015 / Sungwook Lee, Booki Kim
-
Reliability, Availability and Cost Analysis of Large Multi-State Systems with Ageing Components2008 / Krzysztof Kołowrocki, Joanna Soszyńska
-
Improvements in Computational Modelling of Slide Bearings2013 / Ondřej Maršálek, Pavel Novotný, Lubomír Drápal, Václav Píštěk
-
Study on the ride comfort of vehicles driven by in-wheel motors2016 / L. Jin, Y. Yu, Y. Fu
-
Efficiency optimization of a closed indirectly fired gas turbine cycle working under two variable-temperature heat reservoirs2011 / Zheshu Ma, Jieer Wu
-
Application of the entropy information for the optimization of an additional measurements location in thermal systems2012 / Marcin Szega
-
A Numerical study for the efficacy of flow injection on the diminution of rudder cavitation2015 / Dae Won Seo, Seung-Hee Lee, Hyo Chul Kim, Jung Keun Oh
-
The Operation Modes of E/E/PE System and Their Influence on Determining and Verifying the Safety Integrity Level2010 / Tomasz Barnert, Kazimierz Kosmowski, Marcin Śliwiński