Mechanical engineering topic list of research papers
-
Progress in Titanium Metal Powder Injection Molding2013 / Randall German
-
Nanohardness and Residual Stress in TiN Coatings2011 / Luis Carlos Hernández, Luis Ponce, Abel Fundora, Enrique López, Eduardo Pérez
-
Research on Three-Dimensional Unsteady Turbulent Flow in Multistage Centrifugal Pump and Performance Prediction Based on CFD2013 / Zhi-jian Wang, Jian-she Zheng, Lu-lu Li, Shuai Luo
-
Numerical Simulation of Air Inlet Conditions Influence on the Establishment of MILD Combustion in Stagnation Point Reverse Flow Combustor2013 / Xiao Liu, Hongtao Zheng
-
Rolling Bearing Fault Detection Based on the Teager Energy Operator and Elman Neural Network2013 / Hongmei Liu, Jing Wang, Chen Lu
-
Analytical Behavior Prediction for Skewed Thick Plates on Elastic Foundation2011 / Pang-jo Chun, Yun Mook Lim
-
Buckling of Imperfect Thin Cylindrical Shell under Lateral Pressure2008 / R. Lo Frano, G. Forasassi
-
Assessment of Turbulence Models for Flow Simulation around a Wind Turbine Airfoil2011 / Fernando Villalpando, Marcelo Reggio, Adrian Ilinca
-
Traffic Congestion Evaluation and Signal Control Optimization Based on Wireless Sensor Networks: Model and Algorithms2012 / Wei Zhang, Guozhen Tan, Nan Ding, Guangyuan Wang
-
XFEM-Based Analysis for Crack Growth Characteristics of Diffusion Bonded Laminates of Titanium Alloy with Localized Nonwelded Zone2013 / Yang Liu, Yongcun Zhang, Shutian Liu, Shan Xiao, Xiangming Wang, et al.
-
Vehicle Routing Problem with Time Windows and Simultaneous Delivery and Pick-Up Service Based on MCPSO2012 / Xiaobing Gan, Yan Wang, Shuhai Li, Ben Niu
-
Two-Lane Traffic Flow Simulation Model via Cellular Automaton2011 / Kamini Rawat, Vinod Kumar Katiyar, Pratibha Gupta
-
Analytical Expressions of the Efficiency of Standard and High Contact Ratio Involute Spur Gears2013 / Miguel Pleguezuelos, José I. Pedrero, Miryam B. Sánchez
-
Development of a New Piezoelectric Actuator with Slits2013 / Yasutomo Uetsuji, Hiroyuki Kuramae, Kazuyoshi Tsuchiya, Hidetoshi Sakamoto
-
Development of a 3D Parallel Mechanism Robot Arm with Three Vertical-Axial Pneumatic Actuators Combined with a Stereo Vision System2011 / Mao-Hsiung Chiang, Hao-Ting Lin
-
Simple Model-Free Controller for the Stabilization of Planetary Inverted Pendulum2012 / Huanhuan Mai, Ying-Jeh Huang, Xiaofeng Liao, Ping-Chou Wu
-
Vibration Attenuation in Rotating Machines Using Smart Spring Mechanism2010 / Aldemir Ap. Cavalini, Thiago Vianna Galavotti, Tobias Souza Morais, Edson Hideki Koroishi, Valder Steffen
-
Spectral Ratios for Crack Detection Using P and Rayleigh Waves2012 / Enrique Olivera-Villaseñor, Norberto Flores-Guzmán, Ernesto Pineda-León, Jaime Núñez-Farfán, Manuel Carbajal-Romero, et al.
-
Heat transfer of swirling impinging jets ejected from Nozzles with twisted tapes utilizing CFD technique
Abstract This research investigated the forced convection heat transfer by using the swirling impinging jets. This study focused on nozzles, which equipped with twisted tapes via a numerical approach. The computational domain created by utilizing...
2015 / Younes Amini, Mojtaba Mokhtari, Masoud Haghshenasfard, M. Barzegar Gerdroodbary -
Free Flight and Wind Tunnel Measurements of the Drag Exerted on an Archery Arrow
Abstract We describe two support-interference-free measurements of aerodynamic forces exerted on an archery arrow. The first measurement is performed in a wind tunnel with JAXA's 60cm Magnetic Suspension and Balance System, whereas the second...
2013 / K. Okawa, Y. Komori, T. Miyazaki, S. Taguchi, H. Sugiura