Mechanical engineering topic list of research papers
-
Experimental and numerical investigation of thermal energy storage with a finned tube2005 / Aytun� Erek, Zafer ?lken, Mehmet Ali Acar
-
Two efficient iterative algorithms for error prediction in peripheral milling of thin-walled workpieces considering the in-cutting chip
Abstract Due to the deflection of tool and workpiece induced by cutting force, there is a high complexity associated with the prediction of surface form errors in peripheral milling of thin-walled workpieces. Based on the systematic study of...
2013 / Yong-Gang Kang, Zhong-Qi Wang -
Design and Development of an in situ Machining Simulation System Using Augmented Reality Technology
Abstract CNC machining simulation has been developed to validate NC codes and optimize the machining process. Conventional simulation systems are usually performed in virtual environments, and this has the limitation that the operator needs to...
2012 / J. Zhang, S.K. Ong, A.Y.C. Nee -
Explicit and Implicit Extended MLS Difference Methods for Stefan Problems
Abstract This paper presents the explicit and implicit extended moving least squares (MLS) difference methods for solving 1- D Stefan problem. In the Stefan problem, the interfacial boundary involving phase transformation moves and it provokes the...
2011 / Y.C. Yoon -
Shift Control Method based on Morbidity Index GMDH Forecast
Abstract Multi-clutch transmissions usually use a three-segment buffer characteristic curve to shift control, which has a good controlling effect when the clutch runs in a good condition. But when the clutch has problems, it may lead to a worse...
2011 / Chen Man, Ma Biao -
Investigation on heat transfer enhancement and pressure loss of double swirl chambers cooling
Abstract By merging two standard swirl chambers, an alternative cooling configuration named double swirl chambers (DSC) has been developed. In the DSC cooling configuration, the main physical phenomena of the swirl flow in swirl chamber and the...
2013 / Gang Lin, Karsten Kusterer, Dieter Bohn, Takao Sugimoto, Ryozo Tanaka, et al. -
Reduced-order Modeling Method for Longitudinal Vibration Control of Propulsion Shafting
Abstract The propulsion shafting is one typically continuous, elastic and stepped body. To design an active controller for propulsion shafting by applying the modern control theory, an accurate reduced-order model with lumped parameters is required. ...
2012 / Zhang Gan-bo, Zhao Yao -
Consideration On Construction and Development of University Engineering Training Center
Abstract Now Engineering Training Center is in an important development stage, thus it is of great significance for the higher education reform and construction of an innovative society to improve the construction of engineering training center,...
2011 / Xuehua Li, Zhikai Cao, Long Chen, Zhongyun Jiang -
Icing Certification of Civil Aircraft Engines
Abstract Aeroengine icing is an unwanted phenomenon which can normally lead to the hazardous effect to the power of aircraft during routine flight. To be on the safe side, each civil aircraft engine model must fully meet the strict requirements of...
2011 / Yang Bin, Zhou Yanpei -
Control of Corner Separation to Enhance Stability in a Linear Compressor Cascade by Boundary Layer Suction
Abstract Certificating characteristics of stall and surge is an important work for engine airworthiness. Requirements and instructions of these characteristics are issued under CCAR 33.65. For stator cascade, the flow structure of corner separation...
2014 / Jinjing Sun, Yangwei Liu, Lipeng Lu, Qiuhui Wang -
Research on Optimization of Vehicle Routing Problem for Ride-sharing Taxi
Abstract In order to improve transportation efficiency of taxi and mitigate urban traffic congestion, it is necessary to carry out ride-sharing strategy which contributes to reducing operating cost and saving road resources. This study focuses on...
2012 / Yeqian Lin, Wenquan Li, Feng Qiu, He Xu -
Static Aeroelastic Response Analysis of Aircrafts Based on CFD Pressure Distribution
Abstract An analysis method for static aeroelastic response considering the effect of Computational Fluid Dynamics (CFD) aerodynamic pressure distribution was developed in this paper. The aerodynamic pressure and the steady aerodynamic influence...
2013 / Yaokun Wang, Zhiqiang Wan, Chao Yang, Yunzhen Liu -
An adaptive turbo-shaft engine modeling method based on PS and MRR-LSSVR algorithms
Abstract In order to establish an adaptive turbo-shaft engine model with high accuracy, a new modeling method based on parameter selection (PS) algorithm and multi-input multi-output recursive reduced least square support vector regression...
2013 / Jiankang Wang, Haibo Zhang, Changkai Yan, Shujing Duan, Xianghua Huang -
Psychology-Based Research on Unsafe Behavior by Pedestrians When Crossing the Street2015 / T. Ding, S. Wang, J. Xi, L. Zheng, Q. Wang
-
Using the second law of thermodynamic to improve CO2 capture systems
Abstract Among the main challenges of Carbon Capture and Storage (CCS) technologies, the reduction of energy penalties associated with the capture process and the integration of the new process in the design of a complex system - original power...
2011 / Yolanda Lara, Ana Martínez, Pilar Lisbona, Irene Bolea, Ana González, et al. -
Finite elements prediction of thermal stresses in work roll of hot rolling mills
Abstract A simplified numerical approach based on finite elements to compute thermal stresses occurring in work roll of hot rolling mills is here proposed. To decrease both the complexity of the analysis and the computational effort, this approach...
2010 / D. Benasciutti, E. Brusa, G. Bazzaro -
The development of a novel SR-CT technique-originated equipment for microwave sintering
Abstract Microwave sintering has been paid a considerable amount of attention by researches as a novel technology for the preparation of dense structural ceramics recently. However, the mature theory has not been established due to the technical...
2010 / Yongcun Li, Feng Xu, Xiaofang Hu, Hongyan Qu, Zhong Zhang, et al. -
Vector Rotators of Rigid Body Dynamics with Coupled Rotations around Axes without Intersection2011 / Katica R. (Stevanović) Hedrih, Ljiljana Veljović
-
Genetic Algorithm for Multiuser Discrete Network Design Problem under Demand Uncertainty2012 / Wu Juan, Lu Huapu, Yu Xinxin, Bian Changzhi
-
Temperature Effects on the Propagation Characteristics of Love Waves along Multi-Guide Layers of Sio2/Su-8 on St-90°X Quartz2012 / Fangqian Xu, Wen Wang, Jiaoli Hou, Minghua Liu