Mechanical engineering topic list of research papers
-
Study on Vehicle-mounted Overloading Control System for Passenger Vehicles
Abstract For the problem of overloading passenger vehicles, vehicle-mounted overloading control system for passenger vehicles was designed. The system included sensor circuit, sensor control circuit and interface circuit with AT89C51...
2011 / Shanzhen Xu, Qian Zhao -
Modelling dynamics of certain class of discrete multi-body systems based on direct method of the dynamics of relative motion2011 / Krzysztof Zboinski
-
Special issue on "Marine Energy Conversion"2015 / F. Marignetti, H. Yu, L. Cappelli
-
Control strategies for aircraft airframe noise reduction
Abstract With the development of low-noise aircraft engine, airframe noise now represents a major noise source during the commercial aircraft’s approach to landing phase. Noise control efforts have therefore been extensively focused on the airframe...
2013 / Yong Li, Xunnian Wang, Dejiu Zhang -
A Two-Dimensional Micro Scanner Integrated with a Piezoelectric Actuator and Piezoresistors2009 / Chi Zhang, Gaofei Zhang, Zheng You
-
Study of the axial heat conduction in parallel flow microchannel heat exchanger
Abstract In this paper the axial heat conduction in an isosceles right triangular microchannel heat exchanger is numerically investigated, for laminar, 3D, incompressible, single-phase, steady state flow. The behaviour of axial heat conduction in...
2012 / Mushtaq Ismael Hasan, Hayder Mohammed Hasan, Ghassan Adnan Abid -
An investigation into minimising total energy consumption and total weighted tardiness in job shops
Abstract Manufacturing enterprises nowadays face the challenge of increasing energy prices and requirements to reduce their emissions. Most reported work on reducing manufacturing energy consumption today focuses on the need to improve the...
2013 / Ying Liu, Haibo Dong, Niels Lohse, Sanja Petrovic, Nabil Gindy -
Development of a Miniaturized Multisensory Positioning Device for Laser Dicing Technology
Abstract In this study we propose a multisensory laser tracker system for measuring and tracking the TCP (Tool Center Point) of e.g. high precision motion systems. An experimental platform composed of four tracker modules is developed in order to...
2011 / Eric Markweg, Tran Trung Nguyen, Stefan Weinberger, Christoph Ament, Martin Hoffmann -
LAMP Joining between Ceramic and Plastic
Abstract Joining of dissimilar materials is necessary and important from a manufacturing viewpoint. Therefore, the authors have developed a new laser direct joining method between a metal and a plastic which is named Laser Assisted Metal and Plastic ...
2011 / Yousuke Kawahito, Kouji Nishimoto, Seiji Katayama -
A Novel Maximum Power Point Tracking Control for Permanent Magnet Direct Drive Wind Energy Conversion Systems2012 / Ying Zhu, Ming Cheng, Wei Hua, Wei Wang
-
Numerical simulation of fluid flow and heat transfer of supercritical CO2 in micro-porous media
Abstract International attention has been considerably paid for the technology of CO2 capture and storage (CCS) these days because of global warming. In line with the fact that carbon dioxide capture and storage (CCS) technology has been regarded as ...
2011 / Hang Seok Choi, Hoon Che Park, Cheol Huh, Seong-Gil Kang -
Numerical Results on Operating Parameters Influence for a Heat Recovery Adsorption Machine
Abstract In this paper, a detailed thermodynamic and parametric analysis of simple and regenerative cycle of an adsorptive machine using the activated carbon AC-35/methanol as adsorbent/adsorbate pair is given, where the Dubinin-Astakhov equation is ...
2011 / W. Chekirou, R. Boussehain, M. Feidt, A. Karaali, N. Boukheit -
Measurement of kinematics of a flying disc using an accelerometer
Abstract In this study, a tri-axial accelerometer was attached to a flying disc to measure the kinematics during flight. A subject performed disc throwing. High speed video cameras were used to capture release and end points to validate boundary...
2010 / Reno Koyanagi, Yuji Ohgi -
Investigation on the Factors Affecting the Temperature in Urban Distribution Substations and an Energy-Saving Cooling Strategy2011 / Fan Yang, Wei Ran, Tao Chen, Xiaochu Luo
-
A New Full Pose Measurement Method for Robot Calibration2013 / Hoai-Nhan Nguyen, Jian Zhou, Hee-Jun Kang
-
Individual Subjective Initiative Merge Model Based on Cellular Automaton2013 / Yin-Jie Xu, Yu-Guang Chen, Chao Yang, Yi-Chao Pu
-
Idle Operation with Low Intake Valve Lift in a Port Fuel Injected Engine2013 / Adrian Clenci, Adrian Bîzîiac, Pierre Podevin, Georges Descombes, Michael Deligant, et al.
-
Detecting Nano-Scale Vibrations in Rotating Devices by Using Advanced Computational Methods2010 / Raúl M. del Toro, Rodolfo E. Haber, Michael C. Schmittdiel
-
Spectral Entropy, Empirical Entropy and Empirical Exergy for Deterministic Boundary-Layer Structures2013 / LaVar Isaacson
-
Online Semiparametric Identification of Lithium-Ion Batteries Using the Wavelet-Based Partially Linear Battery Model2013 / Dazhong Mu, Jiuchun Jiang, Caiping Zhang