Materials engineering topic list of research papers
-
Nonradiative lifetime extraction using power-dependent relative photoluminescence of III-V semiconductor double-heterostructures2016 / A. W. Walker, S. Heckelmann, C. Karcher, O. Höhn, C. Went, et al.
-
Tetra-methyl substituted copper (II) phthalocyanine as a hole injection enhancer in organic light-emitting diodes2015 / Yu-Long Wang, Jia-Ju Xu, Yi-Wei Lin, Qian Chen, Hai-Quan Shan, et al.
-
Phase diagram of the layered oxide SnO: GW and electron-phonon studies2015 / Peng-Jen Chen, Horng-Tay Jeng
-
Refined Hybrid Microgrid Architecture for the Improvement of Voltage Profile
Abstract Hybrid microgrid is emerging as a flexible and modular solution that integrates various heterogeneous energy resources and loads. This conventional hybrid microgrid architecture can also reduce the number of power conversion stages, when...
2016 / Pinjala Mohana Kishore, Bhimasingu Ravikumar -
Temperature Effects on Organic Lubricants in Cold Forging of AA1050 Alloy
Abstract Lubricants have a key role in cold forging when pressures can reach extreme levels, since they contribute to reduce the high frictional forces occurring at the interface between the tools and billet. However, the adiabatic heating due to...
2016 / Francesco Medea, Andrea Ghiotti, Stefania Bruschi -
Impact damages detection on composite materials by THz imaging
Abstract This paper presents a Non-Destructive Testing (NDT) method based on the penetration properties of terahertz (THz) waves. A CW raster-scanning THz imaging setup, using a 3.8 THz Quantum Cascade Laser as a source, is used to perform NDT of...
2016 / Fabien Destic, Christophe Bouvet -
Stress and structural damage sensing piezospectroscopic coatings validated with digital image correlation2015 / Gregory Freihofer, Joshua Dustin, Hong Tat, Axel Schülzgen, Seetha Raghavan
-
Electrically programmable-erasable In-Ga-Zn-O thin-film transistor memory with atomic-layer-deposited Al2O3/Pt nanocrystals/Al2O3 gate stack2015 /
-
Rational design of Nb-based alloys for hydrogen separation: A first principles study2013 / Byungki Ryu, Hyeon Cheol Park, Eunseog Cho, Kwanghee Kim, Jaeho Lee, et al.
-
Identification of damage based on frequency response function (FRF) data2016 / M. S. A. Sulaiman, M. A. Yunus, A. R. Bahari, M. N. Abdul Rani
-
High Ms Fe16N2 thin film with Ag under layer on GaAs substrate2016 / Xiaowei Zhang, Yanfeng Jiang, Meiyin Yang, Lawrence F. Allard, Jian-Ping Wang
-
Mesoporous β-Co(OH)2 nanowafers and nanohexagonals obtained synchronously in one solution and their electrochemical hydrogen storage properties
Abstract A water/oil two-phase solution strategy has been developed for the synthesis of various β-Co(OH)2 nanostructures. More importantly, two different morphologies of β-Co(OH)2: mesoporous nanowafers and nanohexagons were successfully obtained...
2016 / Longqiang Wang, Jingyuan Fu, Yue Zhang, Xiaoling Liu, Yansheng Yin, et al. -
Durability Of X10CrMoVNb9-1 Steel Tubes Under Low-Cycle Fatigue And Creep Conditions After Bending With Local Induction Heating2015 / M. Cieśla, G. Junak, J. Tomczak, R. Findziński, T. Kawała
-
Bias-induced migration of ionized donors in amorphous oxide semiconductor thin-film transistors with full bottom-gate and partial top-gate structures2012 / Mallory Mativenga, Tae-Ha Hwang, Jin Jang
-
Interface-dependent rectifying TbMnO3-based heterojunctions2011 / Yimin Cui, Yufeng Tian, Wei Liu, Yongfeng Li, Rongming Wang, et al.
-
Trap behaviours characterization of AlGaN/GaN high electron mobility transistors by room-temperature transient capacitance measurement2016 / Bin Dong, Jie Lin, Ning Wang, Ling-li Jiang, Zong-dai Liu, et al.
-
Direct Current and Pulsed Direct Current Plasma Nitriding of Ferrous Materials a Critical Review2016 / Magdalena Łępicka, Małgorzata Grądzka-Dahlke
-
Effect of Technical Quality of Thermomechanical Die Forging of AA2099 Alloy2014 / A. Łukaszek-Sołek
-
Computer-automated tuning of semiconductor double quantum dots into the single-electron regime2016 / T. A. Baart, P. T. Eendebak, C. Reichl, W. Wegscheider, L. M. K. Vandersypen
-
Hole-making processes and their impacts on the microstructure and fatigue response of aircraft alloys2016 / Dan Sun, Patrick Lemoine, Daniel Keys, Patrick Doyle, Savko Malinov, et al.