Mechanical engineering topic list of research papers
-
Experimental Evaluation of Parameter Identification Schemes on an Anthropomorphic Direct Drive Robot2012 / Cesar Chavez-Olivares, Fernando Reyes-Cortes, Emilio Gonzalez-Galvan, Marco Mendoza-Gutierrez, Isela Bonilla-Gutierrez
-
3D Flapping Trajectory of a Micro-Air-Vehicle and its Application to Unsteady Flow Simulation2013 / Lung-Jieh Yang, Fu-Yuen Hsiao, Wen-Tzu Tang, I-Cheng Huang
-
The Dynamics and Sliding Mode Control of Multiple Cooperative Welding Robot Manipulators2012 / Bin Zi, Huihui Sun, Zhencai Zhu, Sen Qian
-
Line Tracking Control of a Two-Wheeled Mobile Robot Using Visual Feedback2013 / G. H., Seul Jung
-
Planning and Control of Stable Walking for a 3D Bipedal Robot2012 / Ching-Long Shih, Wen-Yo Lee, Chia-Pin Wu
-
The Evolution of Cooperative Behaviours in Physically Heterogeneous Multi-robot Systems2012 / Jianhua Yang, Yabo Liu, Zhaohui Wu, Min Yao
-
Stress Wave Propagation in Two-dimensional Buckyball Lattice2016 / Jun Xu, Bowen Zheng
-
Smooth Jerk-Bounded Optimal Path Planning of Tricycle Wheeled Mobile Manipulators in the Presence of Environmental Obstacles2012 / Moharam Habibnejad, Mostafa Nazemizadeh, Hamed Rahimi
-
The Influence of Multi-walled Carbon Nanotubes Additives into Non-edible Biodiesel-diesel Fuel Blend on Diesel Engine Performance and Emissions
Abstract This paper reports on an experimental investigation that was conducted to recommend the most suitable dose level of multi-walled carbon nanotubes (MWCNT) into biodiesel-diesel fuel blend at which the optimum diesel engine performance is...
2016 / Ahmed I. EL-Seesy, Ali K. Abdel-Rahman, Mahmoud Bady, S. Ookawara -
A Comparison of Energy Consumption in Wire-based and Powder-based Additive-subtractive Manufacturing
Abstract The objective of this work is to compare the energy consumption associated with the creation of a small volume of steel by wire-based additive-subtractive manufacturing and powder-based additive-subtractive manufacturing. Additive...
2016 / Marcus A. Jackson, Arik Van Asten, Justin D. Morrow, Sangkee Min, Frank E. Pfefferkorn -
Aerodynamic Optimization of a Winglet Design2013 / S. Belferhat, S.M.A. Meftah, T. Yahiaoui, B. Imine
-
Tactile mouse generating velvet hand illusion on human palm2016 / N. Rajaei, M. Ohka, H. Nomura, H. Komura, S. Matsushita, et al.
-
Analysis of Traffic Capacity on Mountainous Two Lane Highway Adding Climbing Lane2016 / Yunwei Meng, Hailing Li, Hejun Chai, Zongling Yan
-
The Types Division and Severity Threshold of Traffic Conflict on Freeway Interchange2016 / Shen Li, Qiaojun Xiang, Xin Gu, Junchen Dai, Chao Tang, et al.
-
Biomimetics Micro Robot with Active Hardware Neural Networks Locomotion Control and Insect-Like Switching Behaviour2012 / Ken Saito, Minami Takato, Yoshifumi Sekine, Fumio Uchikoba
-
A Study of Force and Position Tracking Control for Robot Contact with an Arbitrarily Inclined Plane2013 / Ye Bosheng, Song Bao, Li Zhengyi, Xiong Shuo, Tang Xiaoqi
-
Node-Gosper Curve-Based Unknown Sensor Localization Using Single Mobile Anchor in Wireless Sensor Networks2016 / C.-C. Chen, S.-B. Wang
-
Research on Dynamics and Stability in the Stairs-climbing of a Tracked Mobile Robot2012 / Weijun Tao, Yi Ou, Hutian Feng
-
Mobility Assistance Design of the Intelligent Robotic Wheelchair2012 / Po Er, Yeh Liang, Kai Wei, Claudius Geiser
-
Research on unmanned combat aerial vehicle robust maneuvering decision under incomplete target information2016 / Y. Wang, C. Huang, C. Tang