Mechanical engineering topic list of research papers
-
Sensitivity of regions of irregular and chaotic vibrations of an asymmetric rotor supported on journal bearings to structural parameters2015 / Piotr Maria Przybylowicz, Zbigniew Starczewski, Piotr Korczak-Komorowski
-
Natural convection heat transfer under constant heat flux wall in a nanofluid filled annulus enclosure
Abstract In this investigation, the Control Volume based Finite Element Method (CVFEM) is used to simulate the natural convection heat transfer of Cu–water nanofluid in an annulus enclosure. The Maxwell–Garnetts (MG) and Brinkman models are also...
2014 / S.M. Seyyedi, M. Dayyan, Soheil Soleimani, E. Ghasemi -
A Novel Parameter for Ramp Metering and Evaluation
Abstract Real and scientific traffic flow parameter are the basis to make efficient traffic control strategy and establish control function and this will leads to an appropriate and impartial reflection to efficiency and equity of control property....
2012 / Jian Li, Yuanhua Jia, Yong Zhang, Feng Chen, Guchang Ao -
Simulation of the Thermal Hydraulic Processes in the Horizontal Steam Generator with the Use of the Different Interfacial Friction Correlations2011 / Vladimir Melikhov, Oleg Melikhov, Yury Parfenov, Alexey Nerovnov
-
Hybrid position-force control for constrained reconfigurable manipulators based on adaptive neural network2015 / Y. Li, G. Wang, B. Dong, B. Zhao
-
ROAD SAFETY IN CANADA2014 / Paul GUTOSKIE
-
Semi-dynamic Simulation of ORC Based Diesel Engine WHR System
Abstract Organic Rankine Cycle (ORC) based engine waste heat recovery (WHR) has been recognised as a promising technology as it can potentially improve the total engine efficiency significantly and has no noticeable effect on engine operation. In...
2015 / Guohong Tian, Yong Zhang, Tony Roskilly -
2D Temperature Analysis of Energy and Exergy Characteristics of Laminar Steady Flow across a Square Cylinder under Strong Blockage2015 / M. Korukcu
-
Rapid evaluation of machine tools with position-dependent milling stability based on response surface model2016 / L. Zhang, W. Gao, D. Zhang, W. Chang, Y. Nie
-
Alternating current electrothermal micromixer with thin film resistive heaters2016 / F. Zhang, H. Chen, B. Chen, J. Wu
-
Solution to the SLAM Problem in Low Dynamic Environments Using a Pose Graph and an RGB-D Sensor2014 / Donghwa Lee, Hyun Myung
-
Energy Coordinative Optimization of Wind-Storage-Load Microgrids Based on Short-Term Prediction2015 / Changbin Hu, Shanna Luo, Zhengxi Li, Xin Wang, Li Sun
-
Influence of Structuring by Abrasive Machining on the Tribological Properties of Workpiece Surfaces
Abstract Surface structuring of workpieces has a significant influence on the tribological properties of contact partners and can therefore lead to a significant increase of the life time of components [1]. To identify an appropriate surface...
2011 / E. Uhlmann, T. Borsoi Klein, L. Hochschild, C. Bäcker -
Control Parameters for Boundary-Layer Instabilities in Unsteady Shock Interactions2012 / LaVar King Isaacson
-
Fast and Stable Electrical Discharge Machining (EDM) by Two-step-ahead Predicted Control
Abstract In order to improve EDM performances, the most important issue is to develop a highly stable control system. As to a serious defect of instability in EDM machining even in EDM adaptive control systems by Minimum-variance (MV) control this...
2016 / Ming Zhou, Jianyang Wu, Jianwei Yang, Dechen Yao -
Impact of Vehicle add-ons on Energy Consumption and Greenhouse Gas Emissions
Abstract The primary objective of this study is to determine the impact of vehicle add-ons on energy consumption and greenhouse gas emissions (mainly CO2) for commonly used fossil fuels in passenger car. Various commonly used vehicle add-ons (police ...
2012 / Harun Chowdhury, Firoz Alam, Iftekhar Khan, Victor Djamovski, Simon Watkins -
Robust <i>H</i><sub>∞</sub> Controller for High Precision Positioning System, Design, Analysis, and Implementation2012 / Safanah M. Raafat, Rini Akmeliawati, Ismael Abdulljabaar
-
Dynamic Self-Adaptive Reliability Control for Electric-Hydraulic Systems2015 / Y. Wan, H. Huang, J. Tian
-
Hydrodynamic lubrication of textured surfaces: A review of modeling techniques and key findings
Abstract Understanding the influence of surface properties (roughness, grooves, discrete textures/dimples) on the performance of hydrodynamically lubricated contacts has been the aim of numerous studies. A variety of different numerical models have...
2015 / Daniel Gropper, Ling Wang, Terry J. Harvey -
Influence of the type of working fluid in the lower cycle and superheated steam parameters in the upper cycle on effectiveness of operation of binary power plant2015 / Aleksander A. Stachel, Sławomir Wiśniewski