Materials engineering topic list of research papers
-
Measurement of anchoring coefficient of homeotropically aligned nematic liquid crystal using a polarizing optical microscope in reflective mode2015 / Sang-In Baek, Sung-Jo Kim, Jong-Hyun Kim
-
Experiments to investigate lift production mechanisms on pitching flat plates2016 / P. R. R. J. Stevens, H. Babinsky
-
Interlocked chiral/polar domain walls and large optical rotation in Ni3TeO62015 / Xueyun Wang, Fei-Ting Huang, Junjie Yang, Yoon Seok Oh, Sang-Wook Cheong
-
Direct Comparison of the Sensitivity of QCMs and AlN-based TFRs Biosensors
Abstract We present the direct comparison of the performance of two gravimetric biosensors based on acoustic resonators, a quartz crystal microbalance and a high frequency AlN-based bulk acoustic wave film solidly mounted resonator (SMR). Both...
2017 / J.M. Escolano, B. Díaz-Durán, J. Olivares, M. Clement, T. Mirea, et al. -
Characterization and Performance Estimation of a MEMS Spirometer
Abstract The electrical characteristics and performance estimation of a MEMS spirometer is reported. The device design incorporates a silicon turbine, integrated magnets, ball bearings, and stators having planar coils. Pneumatic actuation of the...
2017 / Sahar Habibiabad, Yeşim Serinağaoğlu Doğrusöz, Mustafa İlker Beyaz -
Artificial Cells: Synthetic Compartments with Life-like Functionality and Adaptivity2017 / Bastiaan C. Buddingh’, Jan C. M. van Hest
-
Magnetohydrodynamic flow of Casson fluid over a stretching cylinder
Abstract Here the Newtonian heating characteristics in MHD flow of Casson liquid induced by stretched cylinder moving with linear velocity is addressed. Consideration of dissipation and Joule heating characterizes the process of heat transfer....
2017 / M. Tamoor, M. Waqas, M. Ijaz Khan, Ahmed Alsaedi, T. Hayat -
Optical basicity and electronic polarizability of zinc borotellurite glass doped La3+ ions
Abstract Zinc borotellurite glasses doped with lanthanum oxide were successfully prepared through melt-quenching technique. The amorphous nature of the glass system was validated by the presence of a broad hump in the XRD result. The refractive...
2017 / M.K. Halimah, M.F. Faznny, M.N. Azlan, H.A.A. Sidek -
Determination of Microstructure and Phase Composition of Sand-Lime Brick after Autoclaving Process
Abstract The mass for sand-lime products consists of fully organic components: silica sand, quicklime and water. Depending on the proportions of ingredients used, admixtures and additives, the degree of fragmentation of the sand, and autoclaving...
2016 / Ryszard Dachowski, Katarzyna Komisarczyk -
Graphene-zinc Oxide Based Nanomaterials for Gas Sensing Devices
Abstract Herein, we report the preparation of a hybrid material by combination of modified graphene and ZnO. The morphological and compositional analyses of the obtained material have been performed by means of scanning electron microscopy and...
2017 / V. Galstyan, E. Comini, I. Kholmanov, A. Ponzoni, V. Sberveglieri, et al. -
Spin-polarized current injection induced magnetic reconstruction at oxide interface2017 / F. Fang, Y. W. Yin, Qi Li, G. Lüpke
-
Incubation time approach to rock dynamic strength characterization2012 / A. Evstifeev, E. Cadoni, Y. Petrov
-
Non-binary Colour Modulation for Display Device Based on Phase Change Materials2016 / Hong-Kai Ji, Hao Tong, Hang Qian, Ya-Juan Hui, Nian Liu, et al.
-
Piezoresponse force microscopy study on ferroelectric polarization of ferroelectric polymer thin films with various structural configurations2015 / Zongyuan Fu, Jianchi Zhang, Junhui Weng, Weibo Chen, Yulong Jiang, et al.
-
A fuzzy set plasticity model for cyclic loading of granular soils
Abstract A constitutive model for describing the stress–strain behavior of granular soils subjected to cyclic loading is presented. The model is formulated using fuzzy set plasticity theory within the classical incremental plasticity theory...
2016 / Cheng Chen, Lingwei Kong, Xiaoqing Liu, Zhonghui Han -
Dynamics Characterisation of Cymbal Transducers for Power Ultrasonics Applications
Abstract A class V cymbal flextensional transducer is composed of a piezoceramic disc sandwiched between two cymbal-shaped shell end-caps. Depending on the type of piezoceramic, there exists a maximum voltage that can be reached without...
2016 / Andrew Feeney, Fernando Bejarano, Margaret Lucas -
Unified Power Flow Analysis in Natural Gas and Electricity Coupled Networks Considering the Uncertainty of Wind Power
Abstract The widely application of renewable energy in power system makes a big influence on the system security and stability. The main work of this paper was building a comprehensive system model of a natural gas and electricity coupled network...
2016 / Zheng Qiao, Shangyuan Huang, Rui Li, Qinglai Guo, Hongbin Sun, et al. -
On Mode Competition During VIVs of Flexible SFT's Flexible Cylindrical Body Experiencing Lineally Sheared Current
Abstract Most of the floating tunnel and supporting tendon or cable of submerged floating tunnel (SFT) are essentially cylindrical body. Multi-mode vortex-induced vibration (VIV) of these flexible bodies frequently happens in non-uniform flow due to ...
2016 / Weimin Chen, Yilun Li, Yiqin Fu, Shuangxi Guo -
Numerical Investigation of the Failure Phenomena in Adhesively Bonded Joints by Means of a Multi-Linear Equivalent Plastic Stress/Strain Approach
Abstract In this work, a multi-linear material model for elastic-plastic response of ductile adhesives is proposed. Indeed, the proposed formulation allows to evaluate equivalent stress and strains to be used as material model input in FE commercial ...
2016 / A. Riccio, R. Ricchiuto, F. Di Caprio, A. Sellitto, A. Raimondo, et al. -
Molecular Imprinting Studies for Developing QCM-sensors for Bacillus Cereus
Abstract Herein we report the design of a novel molecularly imprinted polymer (MIP) for B. cereus. In a first step, we screened different polymers for their respective affinities towards B. cereus with polymer coated quartz crystal microbalance...
2017 / Eva Spieker, Peter A. Lieberzeit