Mechanical engineering topic list of research papers
-
Remanufacturing Network Design Modeling: A Case of Diesel Particulate Filter
Abstract In the last decade, in order to increase the customer satisfaction, companies faced with challenges like scarce resources and costs during the production process. Reverse logistic approach helps companies to cope with those difficulties by...
2013 / Gozde Kizilboga, Guillaume Mandil, Müjde Erol Genevois, Peggy Zwolinski -
A Three-Axis Force Sensor for Dual Finger Haptic Interfaces2012 / Marco Fontana, Simone Marcheschi, Fabio Salsedo, Massimo Bergamasco
-
Numerical continuation analysis of a three-dimensional aircraft main landing gear mechanism2012 / J. A. C. Knowles, B. Krauskopf, M. Lowenberg
-
Experimental Research of Al6061 on Ultrasonic Vibration Assisted Micro-Milling
Abstract An ultrasonic vibration assisted micro-milling (UVAM) with longitudinal vibration of workpiece is investigated in this paper. The most essential difference between ordinary micro-milling and UVAM lies in the trajectory of cutter tooth. A...
2013 / H. Lian, Z. Guo, Z. Huang, Y. Tang, J. Song -
Effect of Spark Condition on Non-Linear Dynamic Characteristics of Natural Gas Engine
Abstract In the condition of equivalence ratio α=1 and different spark advance angle (SAA), non-linear dynamic characteristics of combustion process in spark ignition (SI) natural gas engine was studied. The results show that the attractors always...
2012 / Wang Li-Yuan, Yang Li-Ping, Jing Hai-Guo, Qaisar Hayat, Liu Guo-Dong -
Unsteady Loads Evaluation for a Wind Turbine Rotor using free wake method
Abstract This paper presents a method for calculating the flow around a wind turbine rotor. The real flow is replaced by a free stream past a vortex model of the rotor. This model consists of lifting vortex lines which replace the blades and a...
2011 / Said Chkir -
Effect of Viscosity Variation on the Micropolar Fluid Squeeze Film Lubrication of a Short Journal Bearing2013 / N. B. Naduvinamani, Archana K. Kadadi
-
Optimisation of the Nonlinear Suspension Characteristics of a Light Commercial Vehicle2013 / Dinçer Özcan, Ümit Sönmez, Levent Güvenç
-
Diffuser and Nozzle Design Optimization by Entropy Generation Minimization2011 / Bastian Schmandt, Heinz Herwig
-
An Elastoplastic Damage Constitutive Model for Cementitious Materials under Wet-Dry Cyclic Sulfate Attack2013 / Da Chen, Chen Du, Xingguo Feng, Feng Ouyang
-
An Experimental Investigation into Chosen Parameters of Diesel-Water Emulsion on Combustion Processes2013 / Pradeep Kumar Arokiasamy Remigious, Annamalai Kandasamy, Premkartikkumar Selvi Rajaram
-
Modeling of Self-Vibratory Drilling Head-Spindle System for Predictions of Bearings Lifespan2011 / F. Forestier, V. Gagnol, P. Ray, H. Paris
-
An ℋ ∞ Optimal Robust Pole Placement with Fixed Transparent Controller Structure on the Basis of Nonnegativity of Even Spectral Polynomials2012 / Andrej Sarjaš, Rajko Svečko, Amor Chowdhury
-
Integrated Approach for a Knowledge-Based Process Layout for Simultaneous 5-Axis Milling of Advanced Materials2011 / F. Klocke, T. Bergs, M. Busch, L. Rohde, M. Witty, et al.
-
Investigation of Solar Hybrid Electric/Thermal System with Radiation Concentrator and Thermoelectric Generator2013 / Edgar Arturo Chávez Urbiola, Yuri Vorobiev
-
Quasiperiodic oscillations and homoclinic orbits in the nonlinear nonlocal Schrödinger equation2013 / F Maucher, E Siminos, W Krolikowski, S Skupin
-
Impactless biped walking on a slope
Abstract Walking without impacts has been considered in dynamics as a motion/force control problem. In order to avoid impacts, an approach for both the specified motion of the biped and its ground reaction forces was presented yielding a combined...
2013 / Lulu Gong, Werner Schiehlen -
Mode identification in impact-induced high-frequency vehicular driveline vibrations using an elasto-multi-body dynamics approach2004 / S Theodossiades, M Gnanakumarr, H Rahnejat, M Menday
-
Motion stability dynamics for spacecraft coupled with partially filled liquid container
Abstract This paper presents a canonical Hamiltonian model of liquid sloshing for the container coupled with spacecraft. Elliptical shape of rigid body is considered as spacecraft structure. Hamiltonian system is an important form of mechanical...
2012 / Salman Ahmad, Baozeng Yue -
Estimation of State of Charge of a Lithium-Ion Battery Pack for Electric Vehicles Using an Adaptive Luenberger Observer2010 / Xiaosong Hu, Fengchun Sun, Yuan Zou