Materials engineering topic list of research papers
-
Understanding and reducing deleterious defects in the metastable alloy GaAsBi2017 / Guangfu Luo, Shujiang Yang, Glen R Jenness, Zhewen Song, Thomas F Kuech, et al.
-
Ageing behavior of extruded Mg–8.2Gd–3.8Y–1.0Zn–0.4Zr (wt.%) alloy containing LPSO phase and γ′ precipitates2017 / C. Xu, T. Nakata, X. G. Qiao, M. Y. Zheng, K. Wu, et al.
-
Seismic Vulnerability of Urban Bridges Due to Liquefaction Using Nonlinear Pushover Analysis and Assessing Parameters for Damage Detection
Abstract Pre-disaster planning strategies and strengthening to ensure certain degree of performance of deficient bridges can reduce the seismic risk to a great extent. Codes have been steadily moving towards performance based designs. This study...
2017 / Kashif Quamar Inqualabi, Rajeev Kumar Garg, K. Balaji Rao -
Chemoresistive Gas Sensor based on SiC Thick Film: Possible Distinctive Sensing Properties Between H2S and SO2
Abstract Commercially available nanosized powder of silicon carbide (named SiC), was thermally, morphologically and structurally characterized. After that, it was screen-printed onto alumina substrates in order to obtain thick films to be tested as...
2017 / A. Gaiardo, P. Bellutti, B. Fabbri, S. Gherardi, A. Giberti, et al. -
An investigation of a new 2D CDM model in predicting failure in HFQing of an automotive panel2015 / Mohamed Mohamed, Nan Li, Liliang Wang, Omer El Fakir, Jianguo Lin, et al.
-
Determining material parameters using phase-field simulations and experiments
Abstract A method to determine material parameters by comparing the evolution of experimentally determined 3D microstructures to simulated 3D microstructures is proposed. The temporal evolution of a dendritic solid-liquid mixture is acquired in situ ...
2017 / Jin Zhang, Stefan O. Poulsen, John W. Gibbs, Peter W. Voorhees, Henning F. Poulsen -
Investigation of the relationships between mechanical properties and microstructure in a Fe-9%Cr ODS steel2016 / Benjamin Hary, Thomas Guilbert, Pierre Wident, Thierry Baudin, Roland Logé, et al.
-
Twin-Induced Plasticity of an ECAP-Processed TWIP Steel2016 / L. Wang, J. A. Benito, J. Calvo, J. M. Cabrera
-
Constrained adaptive neural network control of an MIMO aeroelastic system with input nonlinearities
Abstract A constrained adaptive neural network control scheme is proposed for a multi-input and multi-output (MIMO) aeroelastic system in the presence of wind gust, system uncertainties, and input nonlinearities consisting of input saturation and...
2017 / Yiyong Gou, Hongbo Li, Xinmin Dong, Zongcheng Liu -
Optimization of Fuzzy PID Controller's Parameters
Abstract The paper describes an effective method for determining the optimal parameters of a linear fuzzy PID controller with the use of MATLAB services, referred to as Fuzzy Logic Toolbox and Response Optimization
2017 / Y.I. Kudinov, V.A. Kolesnikov, F.F. Pashchenko, A.F. Pashchenko, L. Papic -
Transient photoreflectance of AlInN/GaN heterostructures2012 / S. Marcinkevičius, V. Liuolia, D. Billingsley, M. Shatalov, J. Yang, et al.
-
Tunable band gap of MoS2-SiC van der Waals heterostructures under normal strain and an external electric field2017 / Luo Min, Xu Yu E, Song Yu Xi
-
Acoustic emission characteristics of reinforced concrete beams with varying percentage of tension steel reinforcement under flexural loading
Abstract Reinforced concrete (RC) flanged beam specimens were tested under incremental cyclic load till failure in flexure. Simultaneously the acoustic emissions (AE) known as transient elastic stress waves released during fracture process in the...
2017 / R. Vidya Sagar -
Atomic layer deposition and properties of mixed Ta2O5 and ZrO2 films2017 / Kaupo Kukli, Marianna Kemell, Marko Vehkamäki, Mikko J. Heikkilä, Kenichiro Mizohata, et al.
-
Microstructures and growth mechanisms of GaN films epitaxially grown on AlN/Si hetero-structures by pulsed laser deposition at different temperatures2015 / Wenliang Wang, Weijia Yang, Yunhao Lin, Shizhong Zhou, Guoqiang Li
-
Evidence for the transition from primary to peritectic phase growth during solidification of undercooled Ni-Zr alloy levitated by electromagnetic field2016 / P. Lü, K. Zhou, H. P. Wang
-
A promising structure for fabricating high strength and high electrical conductivity copper alloys2016 / Rengeng Li, Huijun Kang, Zongning Chen, Guohua Fan, Cunlei Zou, et al.
-
Applications of Multi-height Sensors Data Fusion and Fault-tolerant Kalman Filter in Integrated Navigation System of UAV
Abstract This paper presents a scheme for integrated navigation systems with applications of multi-height sensors data fusion and fault-tolerant Kalman filter(FTKF). It can complete data fusion for multi-height sensors, detect faulty sensors online...
2017 / KeKe Geng, N.A. Chulin -
Flora Health Wireless Monitoring with Plant-Microbial Fuel Cell
Abstract We propose a self-sustainable wireless sensor node capable to monitor both environmental data and flora health state, exploiting a Microbial Fuel Cell combined with a plant. This bio-electrochemical system is used both as a power generator...
2017 / Davide Brunelli, Pietro Tosato, Maurizio Rossi -
Atomistic modeling of the dislocation dynamics and evaluation of static yield stress2015 / A.V. Karavaev, V.V. Dremov, G.V. Ionov