Chemical engineering topic list of research papers
-
Investigations into the effects of volatile biomass tar on the performance of Fe-based CLC oxygen carrier materials2016 / Matthew E Boot-Handford, Nick Florin, Paul S Fennell
-
Numerical Simulation and Experimental Study on Formation of High Concentration of H2 Generated by Gas Explosion2016 / Baiwei Lei, Bing Wu, Yatong Zhao, Muhammad Aqeel Ashraf
-
Physical and chemical characteristics of flue-gas particles in a large pulverized fuel-fired power plant boiler during co-combustion of coal and wood pellets
Abstract Fossil fuel combustion should be decreased in future years in order to lower the CO2 emissions of energy production. The reduction can be achieved by increasing the amount of CO2-neutral fuels in energy production. Here 6–13% of coal was...
2016 / Fanni Mylläri, Panu Karjalainen, Raili Taipale, Pami Aalto, Anna Häyrinen, et al. -
Tailoring the Microstructure of a Solid Oxide Fuel Cell Anode Support by Calcination and Milling of YSZ2016 / Amir Reza Hanifi, Miguel A. Laguna-Bercero, Navjot Kaur Sandhu, Thomas H. Etsell, Partha Sarkar
-
Yield Stress and Low-Temperature Start-Up Torque of Lubricating Greases2016 / F. Cyriac, P. M. Lugt, R. Bosman
-
Transportation of heavy oils using polymer-stabilized oil-in-water emulsions2016 / A. R. Al-Hashmi, T. K. Al-Wahaibi, Y. M. Al-Wahaibi, F. Mjalli, R. Al-Omairi
-
Kinetics study and modelling of steam methane reforming process over a NiO/Al2O3 catalyst in an adiabatic packed bed reactor
Abstract Kinetic rate data for steam methane reforming (SMR) coupled with water gas shift (WGS) over an 18 wt. % NiO/α-Al2O3 catalyst are presented in the temperature range of 300–700 °C at 1 bar. The experiments were performed in a plug flow...
2016 / S.Z. Abbas, V. Dupont, T. Mahmud -
Differences in soluble COD and ammonium when applying inverted phase fermentation to primary, secondary and mixed sludge2015 / L. Negral, E. Maranon, L. Castrillon, Y. Fernandez-Nava
-
Effect of Base Oil Structure on Elastohydrodynamic Friction2016 / Jie Zhang, Andrew Tan, Hugh Spikes
-
Self-preservation and structural transition of gas hydrates during dissociation below the ice point: an in situ study using Raman spectroscopy2016 / Jin-Rong Zhong, Xin-Yang Zeng, Feng-He Zhou, Qi-Dong Ran, Chang-Yu Sun, et al.
-
The Effect of Particle Size of Wollastonite Filler on Thermal Performance of Intumescent Fire Retardant Coating2014 / M. Zia-ul-Mustafa, Faiz Ahmad, Puteri S.M. Megat-Yusoff, Hammaz Aziz
-
Design of Microreactor Flow Channel for Fischer Tropsch Synthesis Using Computational Fluid Dynamic
Abstract In this work, the numerical model was used to investigate the effect of microchannel geometries including channel aspect ratio and cross-sectional area of a microreactor for Fischer – Tropsch reaction performance. The comparative study was...
2016 / Apichaya Theampetch, Wanthana Chaiwang, Nuttawoot Jermkwan, Phavanee Narataruksa, Thana Sornchamni, et al. -
Production of l(+)-lactic acid from acid pretreated sugarcane bagasse using Bacillus coagulans DSM2314 in a simultaneous saccharification and fermentation strategy2016 / Edwin C. van der Pol, Gerrit Eggink, Ruud A. Weusthuis
-
Flux of granular particles through a shaken sieve plate2015 / Pingping Wen, Ning Zheng, Junwei Nian, Liangsheng Li, Qingfan Shi
-
Simulation of multiphase flow in hydrocyclone2013 / P. Rudolf
-
Reticulated porous ceria undergoing thermochemical reduction with high-flux irradiation
Abstract A numerical and experimental analysis is performed on the solar-driven thermochemical reduction of ceria as part of a H2O/CO2-splitting redox cycle. A transient heat and mass transfer model is developed to simulate reticulated porous...
2016 / Simon Ackermann, Michael Takacs, Jonathan Scheffe, Aldo Steinfeld -
Pore-scale dynamics of enzyme adsorption, swelling and reactive dissolution determine sugar yield in hemicellulose hydrolysis for biofuel production2016 / Sajal Kanti Dutta, Saikat Chakraborty
-
Progress in dynamic simulation of thermal power plants
Abstract While the conventional design of thermal power plants is mainly focused on high process efficiency, market requirements increasingly target operating flexibility due to the continuing shift towards renewables. Dynamic simulation is a...
2016 / Falah Alobaid, Nicolas Mertens, Ralf Starkloff, Thomas Lanz, Christian Heinze, et al. -
Effects of applied potential and the initial gap between electrodes on localized electrochemical deposition of micrometer copper columns2016 / Fuliang Wang, Hongbin Xiao, Hu He
-
Kinetic Modeling of Phosphate Adsorption by Preformed and In situ formed Hydrous Ferric Oxides at Circumneutral pH2016 / Yanpeng Mao, Qinyan Yue