Mechanical engineering topic list of research papers
-
A 2-DOF Piezoelectric Inchworm Actuator for Precise Positioning2014 / S. Hua, G. Liu, Y. Lou, Z. Li, Y. Meng
-
Dynamics Performance and Abrasive Wear of the Automotive Drive Shaft2014 / J. Mao, Y. Luo, J. Liu
-
Study on Launch Dynamics of Self-Propelled Artillery Based on Transfer Matrix Method of Multibody System2014 / H. Yu, X. Rui
-
Kinetostatic Analysis of Passively Adaptive Robotic Finger with Distributed Compliance2014 / D. Petkovi, J. Iqbal, S. Shamshirband, A. Gani, N. D. Pavlovi, et al.
-
Measurement Performance Assessment: Dynamic Calibration Compared with Static Calibration Method for Roller Tester of Vehicle Brake Force2014 / G. Xu, J. Su, R. Chen, H. Pan, L. Zhang, et al.
-
Feasibility Study on Crack Detection of Pipelines Using Piezoceramic Transducers2013 / Guofeng Du, Qingzhao Kong, Timothy Lai, Gangbing Song
-
An Improved Method Based on CEEMD for Fault Diagnosis of Rolling Bearing2014 / M. Li, H. Wang, G. Tang, H. Yuan, Y. Yang
-
3D Blade Hydraulic Design Method of the Rotodynamic Multiphase Pump Impeller and Performance Research2014 / Y. Zhang, J. Zhang, H. Zhu, S. Cai
-
Performance Evolution of Phytic Acid Conversion Film in the Forming Process2013 / X. Cui, L. Lin, E. Liu, G. Jin, J. Jin
-
Stiffener Layout Optimization of Inlet Structure for Electrostatic Precipitator by Improved Adaptive Growth Method2014 / J. Ji, X. Ding
-
Recent Developments on Computer Aided Fixture Design: Case Based Reasoning Approaches2014 / H. Hashemi, A. Mohamed Shaharoun, S. Izman, D. Kurniawan
-
Analysis of Thermal Stability in a Convecting and Radiating Two-Step Reactive Slab2013 / O. D. Makinde, M. S. Tshehla
-
Prediction of Mass Transfer Time Relaxation Parameter for Boiling Simulation on the Shell-Side of LNG Spiral Wound Heat Exchanger2014 / Z.-Y. Wu, W.-H. Cai, G.-D. Qiu, Y.-Q. Jiang
-
Development of Delta Wing Aerodynamics Research in Universiti Teknologi Malaysia Low Speed Wind Tunnel2014 / S. Mat, I. S. Ishak, T. Mat Lazim, S. Mansor, M. Said, et al.
-
Comparative Analysis of Bulge Deformation between 2D and 3D Finite Element Models2014 / Q. Qin, S. Shang, D. Wu, Y. Zang
-
Electromechanical Coupled Forced Responses for Microplate2014 / X. LiZhong, F. XiaoRui
-
Design and Implementation of the Control System of an Internal Combustion Engine Test Unit2014 / T. Koc, D. Karayel, B. Boru, V. Ayhan, I. Cesur, et al.
-
Air Damping Analysis in Comb Microaccelerometer2014 / W. Zhou, Y. Chen, B. Peng, H. Yang, H. Yu, et al.
-
Trivariate Isogeometric Analysis for Flexible Multibody Dynamics2013 / T. Pi
-
Manifold Adaptive Kernel Semisupervised Discriminant Analysis for Gait Recognition2013 / Z. Wang, X. Sun, L. Sun, Y. Huang