Materials engineering topic list of research papers
-
Evaluation on Thermal Hazard of Ter-Butyl Hydroperoxide by Using Accelerating Rate Calorimeter
Abstract Organic peroxides are a kind of very hazardous substance because they are capable of self-decomposition when being heated or exposed to the sunlight. In present paper, the thermal hazard of tert-butyl hydroperoxide (TBHP) has been...
2012 / Huiping Liu, Lanyun Gu, Peng Zhu, Zhangrui Liu, Bo Zhou -
Effect of dislocation density on improved radiation hardening resistance of nano-structured tungsten–rhenium
Abstract Rolled tungsten 5wt% rhenium sheet has been annealed to produce two microstructures. As received with a high dislocation density, measured using HR-EBSD, and pancake shaped grains with a thickness of ≈200nm and annealed with equiaxed grains ...
2014 / David E.J. Armstrong, T.B. Britton -
On the continued acceleration of bomb casing fragments following casing fracture
Abstract It has been said that, once a bomb casing has fractured, “detonation gases will then stream around the fragments or bypass them, and the acceleration process stops there.” However, while apparently copious gas flow through casing fractures...
2014 / Michael D. Hutchinson, David W. Price -
Structural and Optical Properties of Nanostructured Zinc Oxide Thin Films by Spray Pyrolysis and Ethanol Sensing
Abstract Polycrystalline Zinc Oxide thin films were deposited on a glass substrate by Spray Pyrolysis technique using zinc acetate dehydrate precursor at 220˚C substrate temperature. The concentration of the solution was 0.05M, the deposited films...
2013 / J. Charles, N. Lawrence, S. Thiruvenkadam -
Development of Short Areca Fiber Reinforced Biodegradable Composite Material
Abstract This study related to the development of bio-degradable composites using areca nut frond fibers for use in low strength applications. The fronds are immersed in water for 72hours to extract the fibers. The extracted fibers were treated with ...
2013 / N.H. Padmaraj, M. Vijay Kini, B. Raghuvir Pai, B. Satish Shenoy -
Crossed ring anchored disk resonator for self-alignment of the anchor
Abstract Misalignment is a problematic challenge in RF MEMS resonators. It causes asymmetry in the ultra symmetric radial contour mode disk resonators and degrades their performance by increasing the insertion loss and decreasing their quality...
2013 / Masoud Baghelani, Habib Badri Ghavifekr, Afshin Ebrahimi -
Frictional Behavior of Bearing Material under Gas Lubricated Conditions
Abstract In this study, a Taguchi method is employed to determine statistically the optimal design parameters, and investigate the effect of gas lubrication on friction behavior of bearing material, which is carbon chromium steel. By selecting L9...
2014 / Mohd Fadzli Bin Abdollah, Mohd Afiq Azfar Mazlan, Hilmi Amiruddin, Noreffendy Tamaldin -
Gradient distribution of radial structure of PAN-based carbon fiber treated by high temperature
Abstract High-performance graphite fibers were prepared and analyzed. The gradient distribution of radial structure of PAN-based carbon fibers was characterized by two different Raman test methods (incident laser beam perpendicular to and parallel...
2014 / Haitao Wang, Yu Wang, Ting Li, Shuai Wu, Lianghua Xu -
Bioceramics for implant coatings
Abstract During the past century, synthetic materials and devices have been developed to the point at which they can be used successfully to replace and/or restore function to diseased or damaged tissues. In the field of orthopedics, the use of...
2003 / Allison A Campbell -
Nanometals2004 / Luis M Liz-Marzán
-
Up close & personal with atoms & molecules
Nature is the best example of a system functioning on the nanometer scale, where the involved materials, energy consumption and data handling are optimized. Opening the doors to the nanoworld the emergence of the scanning tunneling microscope in 1982 and the...
2009 / Hans Peter Lang, Christoph Gerber -
Current trends in biomaterials2008 / John Nicholson
-
Drosophila – a versatile model in biology & medicine
The fruit fly Drosophila melanogaster is a versatile model organism that has been used in biomedical research for over a century to study a broad range of phenomena. There are many technical advantages of using Drosophila over vertebrate models; they are easy and...
2011 / Barbara H. Jennings -
Liquid sensing: smart polymer/CNT composites
Today polymer/carbon nanotube (CNT) composites can be found in sports equipment, cars, and electronic devices. The growth of old and new markets in this area has been stimulated by our increased understanding of relevant production and processing methods, as well...
2011 / Tobias Villmow, Sven Pegel, Andreas John, Rosina Rentenberger, Petra Pötschke -
Polymer science in Japan2008 / A. Abe
-
Simulation Field Effect Transistor Bipolar Graphene Nano-ribbon
Abstract The purpose of this paper is to use software package ATK-SE package, in combination with virtual Nano-Lab (VNL), can be used to investigate a Nano-scale transistor. For the transistor structure we will use a graphene junction device, where...
2015 / S. Masoumi, H. Hajghasem, A. Erfanian, A. Molaei Rad -
Recent Developments of Image Based Measurement Methods for Application to Transonic Flows in Industrial Wind Tunnels
Abstract The experimental investigation of unsteady complex flow fields in wind tunnels requires advanced measurement techniques. The most important of such image based measurement techniques are those for the measurement of planar flow velocity...
2011 / J. KOMPENHANS, J. AGOCS, Y. EGAMI, R. ENGLER, U. FEY, et al. -
Micro Mechanical Model of 3D Woven Composites
Abstract A combined beam model representing the periodicity of the microstructure and micro deformation of 3D woven composites is developed for predicting mechanical properties. The model considers the effects of off axial tension/compression and...
2011 / Chu-wei ZHOU -
Nanofabrication with biomolecules
The advances in biotechnology and nanotechnology are spawning a new and exciting manufacturing tool – bionanofabrication – which enables revolutionary ways of building complex bionanostructures on surfaces with nanometer precision. Here, we highlight the...
2005 / Dominic C. Chow, Matthew S. Johannes, Woo-Kyung Lee, Robert L. Clark, Stefan Zauscher, et al. -
Brazilian Microelectronics Sector Dynamization: Technology Strengthening and Sustainable Development on Production Chains
Abstract The aim of this paper is to assert management mechanisms to support government policies of science technology and innovation, contributing to the identification, planning, and coordination of short, middle and long term integrated actions...
2012 / Rubia Auxiliadora Constancio Quintão, Marco Antonio Silveira, Adalberto Mantovani Martiniano de Azevedo, Kelli Angela Cábia Lima de Miranda