Materials engineering topic list of research papers
-
Progress on Fire and Explosion Suppression Technologies for Light Petroleum Fuel
Abstract This paper addresses the basic concept of fire and explosion suppression technologies for light petroleum fuel, proposes two research directions in fire-resistant fuel and explosion-suppression material technologies, and reviews the main...
2014 / LU Changbo, AN Gaojun, Xiong Chunhua, Bai Chunhua, Zhou Youjie, et al. -
Research on Development and Effectiveness Evaluation Technology of New Environment-friendly Oil Spill Dispersant
Abstract Reasonably using oil spill dispersant has become one of the important emergency means intended to handle offshore oil spill accidents. With the worldwide nonstop occurrence of offshore oil spill accidents, the effect and toxicity influence...
2015 / Qian Guodong, Zhao Yupeng, Ren Xuhe, Chi Jie -
Mass and Energy Balance of NH4-salts pH Swing Mineral Carbonation Process Using Steel Slag
Abstract A basic evaluation of the entire NH4-salts pH swing mineral carbonation process steel slag based system including CO2 capture, ammonia absorption and regeneration of additives, has been investigated to evaluate its feasibility at industrial ...
2014 / Marco Dri, Aimaro Sanna, M. Mercedes Maroto-Valer -
Overview of Micro-Force Sensing Methods2013 / Chao Zhe Ma, Jin Song Du, Yi Yang Liu, Yun Kai Chu
-
Lightweight Concrete: An Alternative for Recycling Cellulose Pulp
Abstract From the analysis of the production process of molded pulp packaging, it can be seen that one of the residues generated in the molding is “pulp”. When this waste cannot be reincorporated into the production line, is recovered by...
2015 / Federico N. Andrés, Loreley B. Beltramini, Anabela G. Guilarducci, Melisa S. Romano, Nestor O. Ulibarrie -
Piezoelectric effect in chemical vapour deposition-grown atomic-monolayer triangular molybdenum disulfide piezotronics2015 / Junjie Qi, Yann-Wen Lan, Adam Z. Stieg, Jyun-Hong Chen, Yuan-Liang Zhong, et al.
-
Knitted Strain Sensors: Impact of Design Parameters on Sensing Properties2014 / Ozgur Atalay, William Kennon
-
A Review of Methodological Approaches for the Design and Optimization of Wind Farms2014 / José Herbert-Acero, Oliver Probst, Pierre-Elouan Réthoré, Gunner Larsen, Krystel Castillo-Villar
-
Experimental investigation on electromechanical deformation of dielectric elastomers under different temperatures
Abstract Under an applied voltage, dielectric elastomers (DEs) produce an actuation strain that is nonlinear, partly because of the material properties. In this study, an experimental characterization is conducted to evaluate how the ambient...
2015 / Lei Liu, Hualing Chen, Bo Li, Junjie Sheng, Junshi Zhang, et al. -
Novel Solar Concentrator Geometry for Point Focus, Low-cost Applications
Abstract Solar concentrators for small scale applications typically make use of parabolic dishes or approximations thereof. Fully three dimensional parabolic dishes are expensive to manufacture whilst approximations to these dishes, i.e. the...
2015 / I. Berryman, N. Jelley -
Design, Fabrication and Characterization of SAW Pressure Sensors for Extreme Operation Conditions
Abstract In this work, the design, fabrication and characterization of a pressure sensor based on a surface acoustic wave (SAW) two-port resonator is presented. The devise is built on a thick ST-Cut quartz substrate focusing low cost production for...
2014 / F. Della Lucia, P. Zambrozi Jr, F. Frazatto, M. Piazzetta, A. Gobbi -
Cumulative Damage of High-strength Cast Iron Alloys for Automotive Applications
Abstract The cumulative damage calculation method generally applied in the automotive sector is the Palmgren-Miner-Hypothesis with its modification according to Haibach. In several design codes the theoretical Palmgren-Miner damage sum Dth = 1.0 is...
2015 / S. Schoenborn, H. Kaufmann, C.M. Sonsino, R. Heim -
The Effect of Ball Milling & Reinforcement Percentage on Sintered Samples of Aluminium Alloy Metal Matrix Composites
Abstract SiC, Al2O3 and Graphene are the major reinforcement in aluminium-based composites, which have been developing rapidly in recent years. This paper focuses on the effect of ball milling & reinforcement percentage on mechanical properties...
2014 / P. Ashwath, M. Anthony Xavior -
Research And Characterization Of Cu – Graphene, Cu-CNT’s Composites Obtained By Mechanical Synthesis2015 / P. Kwaśniewski, G. Kiesiewicz, T. Knych, A. Mamala, M. Gniełczyk, et al.
-
Low Friction Cryostat for HTS Power Cable of Dutch Project
Abstract Particulars of 6km long HTS AC power cable for Amsterdam project are: a cable has to fit in an annulus of 160mm, with only two cooling stations at the cable ends [1]. Application of existing solutions for HTS cables would result in...
2012 / Oleg Chevtchenko, Roy Zuijderduin, Johan Smit, Dag Willén, Heidi Lentge, et al. -
Design Principles of Residential Spaces to Promote Children's Creativity
Abstract Due to growth ages, activation, promotion of creativity in the children is very important. In order to improving creativity, there are some methods to encourage children's mind to new thinking and develop the creativity. One of these...
2012 / Mohsen Faizi, Amirreza Karimi Azari, Saeid Norouzian Maleki -
Research and Application of Time Workflow Model Based on Timing Constraint Petri Nets
Abstract In order to visualize time information of the complex workflow system, time parameter concept is firstly introduced to workflow model, and then a new modeling and time parameters calculating method for the practical business process system...
2011 / Hui Pang, Zong-de Fang, Hong-yan Li, Xiao-hui Yang -
Protochordate amphioxus is an emerging model organism for comparative immunology
Abstract Protochordate amphioxus is an extant invertebrate regarded quite recently as a basal chordate. It has a vertebrate-like body plan including a circulation system with an organization similar to that of vertebrates. However, amphioxus is less ...
2009 / Shicui Zhang, Yujun Liang, Guangdong Ji, Zhimeng Zhuang -
In-situ Water Based Emulsion Copolymerization of Styrene/ Ethylhexyl Acrylate in Presence of Cloisite 15A
Abstract Nowadays, due to the outstanding chemical and physical properties of nanomaterials such as montmorillonite, which is resulted from increased surface area to volume ratio of montmorillonite platelets (high aspect ratio), they are using in...
2015 / N. Nemati, F. Afshar Taromi, M. Mirzataheri -
Magnetorheology in an aging, yield stress matrix fluid2012 / Jason P. Rich, Patrick S. Doyle, Gareth H. McKinley