Chemical engineering topic list of research papers
-
Utilization of waste lignin to prepare controlled-slow release urea2016 / Jamshid Behin, Nader Sadeghi
-
Hydrogen-rich Syngas Production from Ethanol Dry Reforming on La-doped Ni/Al2O3 Catalysts: Effect of Promoter Loading
Abstract Ethanol dry reforming has been studied over La-promoted Ni catalysts supported on Al2O3 with different promoter loadings at varying CO2 partial pressure of 20-50kPa. Catalysts were prepared via co-impregnation technique and characterized...
2016 / Mahadi B. Bahari, Boon Chin Goo, Thong L.M. Pham, Tan Ji Siang, Huong T. Danh, et al. -
The flow separation delay in the boundary layer by induced vortices2016 / Ishtiaq A. Chaudhry, Tipu Sultan, Farrukh A. Siddiqui, M. Farhan, M. Asim
-
A method for the determination and correction of the effect of thermal degradation on the viscoelastic properties of degradable polymers
Abstract Small amplitude oscillatory shear is carried out during isothermal degradation of poly(lactic acid) (PLA) in order to determine the evolution of the characteristic relaxation time with degradation time and temperature. After reducing the...
2016 / Gabriel Y.H. Choong, Davide S.A. De Focatiis -
The Engineering Communication Networks – The Issues of Use of Standards for the Information Representation in Design, Construction and Operation
Abstract An important aspect of creation and implementation of BIM-technology in the practice of design, construction and operation is the formation of standards for the submission of information elements BIM-models. In the article the data format...
2016 / Pavel Kagan -
Remediation of DIPA Contaminated Wastewater Using Visible Light Active Bimetallic Cu-Fe/TiO2 Photocatalyst
Abstract Alkanolamine is widely applied in industry usually for gas treatment process to remove acid gases prior to utilization. Though the absorbent is recycled through the system, some carry over into water stream is unavoidable. Due to high...
2016 / Raihan Mahirah Ramli, Chong Fai Kait, Abdul Aziz Omar -
Tailoring Pore Structure of Ultralight Electrospun Sponges by Solid Templating2016 / Fabian Deuber, Sara Mousavi, Marco Hofer, Christian Adlhart
-
Holographic microscopy and microfluidics platform for measuring wall stress and 3D flow over surfaces textured by micro-pillars2016 / Humberto Bocanegra Evans, Serdar Gorumlu, Burak Aksak, Luciano Castillo, Jian Sheng
-
Experimental Studies and the Chemical Kinetics Modelling of Oxidation of Hydrogen Sulfide Contained in Biogas
Abstract This paper presents the results of experimental and numerical research on the process of biogas air combustion. The purpose of the study was to determine the effect of biogas CO2 content on: (a) variations in SO2 concentrations in flue gas, ...
2016 / Wojciech Jerzak, Monika Kuźnia, Artur Szajding -
Physical-chemical Properties of Aqueous TBAOH Solution for Gas Hydrates Promotion
Abstract Gas hydrates attract the attention of many industries for various potential applications such as gas separation and storage. To industrialize the gas hydrate technology, rapid hydrate formation at mild conditions is crucial. Chemical...
2016 / Omar Nashed, Josephine Chin Hui Koh, Bhajan Lal -
Natural convection in circular enclosures heated from below for various central angles
Abstract Two-dimensional numerical simulations have been performed to study natural convection in circular enclosures filled with water considering different central angles. Continuity, momentum and energy equations are solved assuming Boussinesq...
2016 / Seyed Milad Mirabedin, Fatola Farhadi -
Kinetics of Pyrolysis of Mixed Municipal Solid Waste-A Review
Abstract Municipal solid waste management is one of the major challenges faced by most of the developing countries like India. The scarcity of land due to large population and increasing waste production due to urbanization impose a challenge to...
2016 / V. Chhabra, Y. Shastri, S. Bhattacharya -
Bona-fide method for the determination of short range order and transport properties in a ferro-aluminosilicate slag2016 / Konstantinos T. Karalis, Dimitrios Dellis, Georgios S. E. Antipas, Anthimos Xenidis
-
Production of starch nanoparticles by dissolution and non-solvent precipitation for use in food-grade Pickering emulsions
Abstract The aim of this study was to investigate non-solvent precipitation of starch to produce nanoparticles that could be used in Pickering emulsions. The material used was waxy maize, modified with octenyl succinic anhydride. Different methods...
2016 / Hisfazilah Saari, Catalina Fuentes, Malin Sjöö, Marilyn Rayner, Marie Wahlgren -
In situ 3D topographic and shape analysis by synchrotron radiation X-ray microtomography for crystal form identification in polymorphic mixtures2016 / Xian-Zhen Yin, Ti-Qiao Xiao, Ashwini Nangia, Shuo Yang, Xiao-Long Lu, et al.
-
Accuracy and efficiency improvements in synthetic eddy methods.
Abstract With performance in mind, we propose two general improvements to the popular class of turbulent inlet boundary conditions known as the ‘synthetic eddy method’, originally proposed 10 years ago by Jarrin 2006. Our updated version offers...
2016 / A. Skillen, A. Revell, T. Craft -
Adsorption and mechanism of cellulase enzymes onto lignin isolated from corn stover pretreated with liquid hot water2016 / Xianqin Lu, Xiaoju Zheng, Xuezhi Li, Jian Zhao
-
Heat Transfer and Energy Storage Performance of Methane Reforming with Carbon Dioxide in Semi-cavity Reactor
Abstract The heat transfer and energy storage performance of methane reforming with carbon dioxide in a semi-cavity reactor catalyzed by Ni/Al2O3 are numerically investigated. The concentrated solar energy flux is calculated by Gaussian distribution ...
2016 / Qinyuan Yuan, Jing Ding, Jianfeng Lu, Tao Yu, Weilong Wang -
Slip-Effect Functional Air Filter for Efficient Purification of PM2.52016 / Xinglei Zhao, Shan Wang, Xia Yin, Jianyong Yu, Bin Ding
-
Numerical investigation of microwave-assisted pyrolysis of lignin
Abstract A comprehensive three-dimensional mathematical model is developed for studying the microwave-assisted pyrolysis of biomass. Kraft Lignin is considered as biomass feedstock in the model, and a mixture of lignin and char, is used as the...
2016 / Siddharth Gadkari, Beatriz Fidalgo, Sai Gu