Electrical engineering, electronic engineering, information engineering topic list of research papers
-
Sustainable Cutting Process for Milling Operation using Disturbance Observer
Abstract This paper focuses on design of disturbance force observer for sustainable machining process in milling application. In milling process, cutting force acts directly on work surfaces thus producing external impact on the drives system of the ...
2016 / Z. Jamaludin, J. Jamaludin, T.H. Chiew, L. Abdullah, N.A. Rafan, et al. -
A First Approach to Solar Aviation with the Use of Axiomatic Design
Abstract In most of the existing solar airplanes, solar cells are allocated on the top of the wing. From the perspective of Axiomatic Design, this configuration creates a dependency between power, endurance and wing load. The aim of this article is...
2015 / Joan B. Rodriguez, Carlos Gil Morales, Efrén M. Benavides -
HTTPS traffic analysis and client identification using passive SSL/TLS fingerprinting2016 / Martin Husák, Milan Čermák, Tomáš Jirsík, Pavel Čeleda
-
Filter Banks for Next Generation Multicarrier Wireless Communications2010 / Markku Renfors, Pierre Siohan, Behrouz Farhang-Boroujeny, Faouzi Bader
-
High-resolution images based on directional fusion of gradient2016 / Liqiong Wu, Yepeng Liu, Brekhna, Ning Liu, Caiming Zhang
-
Performance of optimal hierarchical type 2 fuzzy controller for load–frequency system with production rate limitation and governor dead band
Abstract Controlling load–frequency is regarded as one of the most important control-related issues in design and exploitation of power systems. Permanent frequency deviation from nominal value directly affects exploitation and reliability of power...
2016 / Mohsen Ebrahimian Baydokhty, Assef Zare, Saeed Balochian -
OFDMA Architectures, Protocols, and Applications2009 / VictorCM Leung, AlisterG Burr, Lingyang Song, Yan Zhang, ThomasMichael Bohnert
-
Operating principle of Soft Open Points for electrical distribution network operation
Abstract Soft Open Points (SOPs) are power electronic devices installed in place of normally-open points in electrical power distribution networks. They are able to provide active power flow control, reactive power compensation and voltage...
2015 / Wanyu Cao, Jianzhong Wu, Nick Jenkins, Chengshan Wang, Timothy Green -
Permittivity of a composite of cellulose, mineral oil, and water nanoparticles: theoretical assumptions2015 / P. Żukowski, T. N. Kołtunowicz, K. Kierczyński, P. Rogalski, J. Subocz, et al.
-
Sound based indoor and outdoor environment detection for seamless positioning handover
Abstract In this paper, we propose a sound-based indoor and outdoor environment detection method to realize seamless positioning handover for in-and-outdoor integrated positioning systems. The proposed method uses a special chirp sound probe which...
2016 / Rakmin Sung, Suk-hoon Jung, Dongsoo Han -
Adaptive double-integral-sliding-mode-maximum-power-point tracker for a photovoltaic system2015 / Bidyadhar Subudhi, Raseswari Pradhan
-
Correction of Rotor Rotation Irregularity of Permanent Magnet Synchronous Motor in a Controlled Synchronous Mode
Abstract While the permanent magnet synchronous motor (PMSM) operation in the synchronous mode rotor speed average value coincides with current frequency in the windings by definition. However instantaneous value of rotation speed can differ from...
2015 / S.G. Voronin, D.A. Kurnosov, D.V. Korobatov, A.S. Kulmukhametova -
Real-time construction and visualisation of drift-free video mosaics from unconstrained camera motion2015 / Mateusz Brzeszcz, Toby P. Breckon
-
Parallel relaxation-based joint dynamic state estimation of large-scale power systems2015 / Hadis Karimipour, Venkata Dinavahi
-
Shapeable maximum-power point-tracking algorithm to improve the stability of the output behavior of a thermoelectric-solar hybrid energy-harvesting system
Abstract This study presents the development of a novel maximum-power point-tracking (MPPT) method based on an input shaping scheme controller. The proposed method that changes the initial input response into a shapeable MPPT algorithm is designed...
2016 / A. M. Yusop, R. Mohamed, A. Ayob, A. Mohamed -
Real-Time Propagation Measurement System and Scattering Object Identification by 3D Visualization by Using VRML for ETC System2009 / Minseok Kim, Jun-ichi Takada, Tetsuo Ando, Ryuji Soma
-
Optimal LQR controller in CSC based STATCOM using GA and PSO2014 / Sandeep Gupta, Ramesh Kumar Tripathi
-
An interactive approach for functional prototype recovery from a single RGBD image2016 / Yuliang Rong, Youyi Zheng, Tianjia Shao, Yin Yang, Kun Zhou
-
Estimation of break-lock in PLL synthesizers for monopulse radar applications: Experimental and simulation approach
Abstract This work presents and estimates the break-lock in phase locked loop (PLL) synthesizers for monopulse radar applications through experimental measurements and computer simulation. Sinusoidal continuous wave (CW) and linear frequency...
2015 / Harikrishna Paik, N.N. Sastry, I. SantiPrabha -
Automatic tuning of paper machines cross-direction controllers via linear matrix inequalities
Abstract The paper machine cross-direction (CD) process is a large-scale spatially distributed system. It is known to be severely ill-conditioned as the gain rolls down to zero for some of the process directions. This article presents an automatic...
2015 / Mohammed E. Ammar, Guy A. Dumont