Electrical engineering, electronic engineering, information engineering topic list of research papers
-
Failover in Cellular Automata
Abstract This paper studies a phenomenon called failover, and shows that this phenomenon (in particular, stateless failover) can be modeled by Game of Life cellular automata. This is the first time that this sophisticated real-life system behavior...
2011 / Shailesh Kumar, Shrisha Rao -
The Circuit Design of Residual Voltage Test For Electric Products
Abstract Many national standards have requirements about the maximum value of residual voltage for electrical equipments[1], it requires to measure residual voltage accurately, the human body may have a certain degree of security risk if the...
2012 / Qian Xiaoyao, Yuan Jia, Qian Jiawei, Zhu Jiang, Wang Yu -
Multiple access communications in future-generation wireless networks2012 / Norman Abramson, Claudio Sacchi, Boris Bellalta, Alexey Vinel
-
Technology development with an agenda: Interventions to emphasize values in design2011 / Katie Shilton
-
Improving Power Quality by Smart Load
Abstract This article analyzes the influence to the power quality produced by load, pointing out that common load can become smart load to improve power quality with the application of computer technology, digitized technology and information...
2012 / Bao-shu Li, Yu-min Ge -
Data transport between visualization web services for medical image analysis
Abstract With the rapid development of IT data driven experiments and simulations have become very advanced and complicated. The amount and complexity of scientific data increase exponentially. Nowadays the challenge is to efficiently support...
2010 / Spiros Koulouzis, Elena Zudilova-Seinstra, Adam Belloum -
MPCM: a hardware coder for super slow motion video sequences2013 / Estefanía Alcocer, Otoniel López-Granado, Roberto Gutierrez, Manuel P Malumbres
-
Blind recognition of binary cyclic codes2013 / Zhou Jing, Huang Zhiping, Su Shaojing, Yang Shaowu
-
Adiabatic Two-Phase CPAL Flip-Flops Operating on Near-Threshold and Super-Threshold Regions
Abstract Low-power adiabatic flip-flops operating on near-threshold and super-threshold regions are investigated in this paper. The flip- flops are realized using two-phase CPAL (complementary pass-transistor adiabatic logic) circuits. A traffic...
2012 / Zheming Xin, Jianping Hu, Qi Chen -
Energy Efficiency and Network Lifetime Maximization in Wireless Sensor Networks Using Improved Ant Colony Optimization
Abstract Improving network lifetime is the fundamental challenge of wireless sensor networks. One possible solution consists in making use of mobile sinks. Sink mobility along a constrained path can improve the energy efficiency in wireless sensor...
2012 / Anil Kumar, Anil Thomas -
Low Power Pipelined Dwt-Idwt Architecture for Ofdm System on Fpga
Abstract OFDM systems are widely used in most of the wireless communication systems. OFDM achieves better bandwidth efficiency and data rate. FFT module in OFDM system is being replaced with DWT to reduce complexities in hardware implementation. In...
2012 / Veena M.B, M.N. Shanmukha Swamy -
Leakage Power Reduction Techniques in Deep Submicron Technologies for VLSI Applications
Abstract The leakage power dissipation has become one of the most challenging issues in low power VLSI circuit designs especially with on-chip devices as it doubles for every two years[4]-[5]. The scaling down of threshold voltage has contributed...
2012 / M.Geetha Priya, K. Baskaran, D. Krishnaveni -
Localization using iterative angle of arrival method sharing snapshots of coherent subarrays2011 / Shun Kawakami, Tomoaki Ohtsuki
-
Mercury-Waterfilling for Generalized Multicarrier Signaling2013 / Adrian Kliks
-
Phase and Quadrature Pulsed Bias LC-CMOS VCO2011 / Stefano Perticaroli, Fabrizio Palma, Adriano Carbone
-
Inter-Network Resource Sharing in IEEE 802.22 Networks2012 / Carla Passiatore, Pietro Camarda
-
The Design of a New Type of Single-phase Multi-functional Argon Arc Welder
Abstract In order to meet the demand of the market for small size yet multi-purpose argon arc welder, especially the demand for single-phase optional arc welding power of 380V/200V, the author adopts advanced design concepts and technical skills...
2011 / Litao Liu -
An Analysis of Processes, Risks, and Best Practices for Use in Developing Systems Engineering Process Simulators
Abstract Systems engineering simulation models provide a valuable means to understand and learn important concepts related to systems engineering. Simulators can be used for education and as decision support systems in order to evaluate the dynamic...
2012 / Susan Ferreira, Misagh Faezipour -
Flexible Frequency-Band Reallocation Networks Using Variable Oversampled Complex-Modulated Filter Banks2006 / Håkan Johansson, Per Löwenborg
-
A 5th-order ΣΔ modulator with combination of op-Amp and CBSC circuit for ADSL applications2011 / M. Zamani, M. Taghizadeh, M. Naser Moghadasi, B. S. Virdee