Chemical engineering topic list of research papers
-
AM600: A New Look at the Nuclear Steam Cycle
Abstract Many developing countries considering the introduction of nuclear power find that large-scale reactor plants in the range of 1,000 MWe to 1,600 MWe are not grid appropriate for their current circumstance. By contrast, small modular reactors ...
2016 / Robert M. Field -
Comparison of Knock Indexes Based on CFD Analysis
Abstract Recent trends in gasoline engines, such as downsizing, downspeeding and the increase of the compression ratio make knocking combustions a serious limiting factor for engine performance. A detailed analysis of knocking...
2016 / Enrico Corti, Claudio Forte, Giulio Cazzoli, Davide Moro, Stefania Falfari, et al. -
Influence of particle arrangement on the permittivity of an elastomeric composite2017 / Peiying J. Tsai, Suchitra Nayak, Suvojit Ghosh, Ishwar K. Puri
-
Water Glass as a Promising Agent for the Removal of Cr and P from Drinking Water
Abstract The paper deals with the possibilities of innovation in water treatment. Attention is focused on the possibilities of using water glass in removing heavy metals and nutrients in water treatment. The partial results are presented from the...
2016 / Tomáš Kučera, Renata Biela, Zdeněk Zelený -
Quantitative evaluation on the characteristics of activated sludge granules and flocs using a fuzzy entropy-based approach2017 / Fang Fang, Li-Li Qiao, Bing-Jie Ni, Jia-Shun Cao, Han-Qing Yu
-
Effect of Coriolis and centrifugal forces on flow and heat transfer at high rotation number and high density ratio in non orthogonally internal cooling channel
Abstract Numerical predictions of three-dimensional flow and heat transfer are performed for a two-pass square channel with 45° staggered ribs in non-orthogonally mode-rotation using the second moment closure model. At Reynolds number of 25,000, the ...
2016 / Brahim Berrabah, Miloud Aminallah -
Enhancing mung bean hydration using the ultrasound technology: description of mechanisms and impact on its germination and main components2016 / Alberto Claudio Miano, Jessica da Costa Pereira, Nanci Castanha, Manoel Divino da Matta Júnior, Pedro Esteves Duarte Augusto
-
Physical Properties of Highly Active Liquor Containing Molybdate Solids
Abstract The reprocessing of irradiated nuclear fuel at Sellafield produces a nitric acid based Highly Active Liquor (HAL) waste. The liquor, containing fission products and process additives, is concentrated in an evaporator in order to reduce the...
2016 / Barbara Dunnett, Tracy Ward, Rachel Roberts, Jonathan Cheesewright -
Highly conductive, printable pastes from capillary suspensions2016 / Monica Schneider, Erin Koos, Norbert Willenbacher
-
Assessment of Coating Performance on Waterwalls and Superheaters in a Pulverised Fuel-Fired Power Station2017 / Nigel Simms, Maud Seraffon, Andy Pidcock, Colin Davis
-
Optimal control of enzymatic hydrolysis of lignocellulosic biomass
Abstract Cellulose hydrolysis is a key step in lignocellulosic ethanol production. At present, commercial production of lignocellulosic ethanol is limited due to the long hydrolysis times and requirement of large quantity of expensive enzymes....
2016 / Fenila F., Yogendra Shastri -
Construction particleboards made from rapeseed straw glued with hybrid pMDI/PF resin2016 / Dorota Dukarska, Rafał Czarnecki, Dorota Dziurka, Radosław Mirski
-
Blade-coated sol-gel indium-gallium-zinc-oxide for inverted polymer solar cell2016 / Yan-Huei Lee, Pei-Ting Tsai, Chia-Ju Chang, Hsin-Fei Meng, Sheng-Fu Horng, et al.
-
On Cattaneo–Christov heat flux in the flow of variable thermal conductivity Eyring–Powell fluid
Abstract Here Cattaneo–Christov heat flux model is employed for heat transfer in the stagnation point flow due to stretching cylinder. This consideration modifies the Fourier’s law of heat conduction through thermal relaxation time....
2017 / Tasawar Hayat, Muhammad Ijaz Khan, Muhammad Waqas, Ahmed Alsaedi -
Radiotracer investigations to study the hydrodynamic characteristics of continuous phase in a pulsed sieve plate extraction column2013 / G.U. Din, I.H. Khan, I.R. Chughtai, M.H. Inayat, J.H. Jin
-
How do liquid fuel physical properties affect liquid jet development in atomisers?2016 / Georgios Charalampous, Yannis Hardalupas
-
Temperature Approach Optimization in the Double Pipe Heat Exchanger with Groove2016 / Putu Wijaya Sunu, Daud Simon Anakottapary, Wayan G. Santika
-
Stability behavior of non-surfactant water-in-diesel emulsion fuel using microscopic observation2016 / Siti Amiliyana Norazni, Wira Jazair Yahya, Ahmad Muhsin Ithnin, Hasanuddin Abd Kadir, Ili Fatimah Abd Razak, et al.
-
Scale-up and process integration of sugar production by acidolysis of municipal solid waste/corn stover blends in ionic liquids2017 / Chenlin Li, Ling Liang, Ning Sun, Vicki S. Thompson, Feng Xu, et al.
-
Origin of Self-preservation Effect for Hydrate Decomposition: Coupling of Mass and Heat Transfer Resistances2015 / Dongsheng Bai, Diwei Zhang, Xianren Zhang, Guangjin Chen